Filter
Top Products
Daily use
Load the laundry
Open the door by carefully
pulling the door handle
outwards. Place the laun-
dry in the drum, one item
at a time, shaking them
out as much as possible.
Close the door.
Make sure that no laundry
stays between the seal and
the door. There is a risk of
water leakage or damage
to the laundry.
Measure out the detergent and the fabric softener
Pull out the dispenser drawer until it stops. Measure
out the amount of detergent required, pour it into the
main wash compartment
or in the appropriate com-
partment if the selected programme/option it requires
(see more details in "Detergent dispenser drawer").
If required, pour fabric softener into the compartment
marked
(the amount used must not exceed the
«MAX» mark in the drawer). Close the drawer gently.
Select the required programme by means of the
programme selector dial (1)
Turn the programme selector dial to the required pro-
gramme.
The green pilot light of button 7 starts to flash. The selec-
tor dial can be turned either clockwise or anticlockwise.
Turn the selector dial to position to reset the pro-
gramme/to switch the machine OFF.
At the end of the programme the selector dial must be
turned to position
, to switch the machine off.
Important! If you turn the programme selector dial to
another programme when the machine is working, the red
pilot light of button 7 will blink 3 times and the
message
Err
is displayed to indicate a wrong selection.
The machine will not perform the new selected
programme.
Select the spin speed by pressing button 2
When selecting a programme, the appliance proposes au-
tomatically the maximum spin speed provided for that
programme. (See "Washing programmes" for the maxi-
mum allowed spin speed).
Press this button repeatedly to change the spin speed, if
you want your laundry to be spun at a different speed. The
relevant pilot light illuminates.
Select the available options by means of buttons 3,
4, 5 and 6
Depending on the programme, different options can be
combined. These must be selected after choosing the de-
sired programme and before starting the programme.
When these buttons are pressed, the corresponding pilot
lights illuminate. When they are pressed again, the pilot
lights go out. If an incorrect option is selected, the inte-
grated red pilot light of the button 7 flashes 3 times and
the message
Err
is displayed.
For the compatibility among the washing programmes and
the options see chapter «Washing programmes».
Start the programme by pressing button 7
To start the selected programme, press this button; the
corresponding green pilot light stops blinking.
The pilot light 9 illuminates to indicate that the appliance
starts operating and the door is locked.
If you have chosen a delayed start, the machine will begin
the countdown.
Important! If an incorrect option is selected, the message
Err
is displayed for a few seconds and the red pilot light of
this button blinks 3 times.
12