Filter
Top Products
15
Operating sequence
Load the laundry
Open the door by
carefully pulling the
door handle outwards.
Place the laundry in the
drum, one item at a
time, shaking them out
as much as possible. Close the door.
Measure out the detergent and the fabric
softener
Pull out the dispenser drawer until it stops.
Measure out the amount of detergent required,
pour it into the main wash compartment
and, if you wish to carry out a programme with
the prewash phase, pour it into the
compartment marked .
If required, pour fabric softener into the
compartment marked (the amount used
must not exceed the «MAX» mark in the
drawer). Close the drawer gently.
Select the required programme by means of
the programme selector dial
(1)
Turn the programme selector dial to the
required programme.
The green light of button 5 starts to flash.
It can be turned either clockwise or
anticlockwise.
On position «Off» the programme is reset and
the machine is switched Off.
At the end of the programme the selector
dial must be turned to position «Off», to
switch the machine off.
ATTENTION!
If you turn the programme selector dial to
another programme when the machine is
working, the red pilot light of button
5 will flash
3 times to indicate a wrong selection. The
machine will not perform the new selected
programme.
Select the spin speed or Rinse Hold option
by pressing button
2
The relevant light will light up.
When selecting a programme, the light
corresponding to the maximum speed allowed
for that programme will illuminate (refer to the
section «Programme table» for the maximum
allowed spin speed).
Select the desired option by means of
buttons 3 and 4
Depending on the programme, different
functions can be combined. These must be
selected after choosing the desired programme
and before pressing the button
5.
For the compatibility of the options with the
washing programmes, refer to the section
«Programme table».
Start the programme by pressing button
5
To start the selected programme, press this
button; the corresponding green pilot light
stops flashing.
On programme progress display the pilot light
A illuminates to indicate that the appliance
starts operating and the door is locked.
IMPORTANT!
If an option which is not compatible with the set
wash programme is selected, the red light of
this button flashes for 3 times.
132952260.qxd 20/05/2009 10.35 Pagina 15