Filter
Top Products
25
If necessary, check the
setting with a spirit
level.
Water inlet
An inlet hose is supplied and can been found
inside the machine drum.
Do not use the hose from your previous
machine to connect to the water supply.
1. Open the porthole and extract the inlet
hose.
2.Connect the hose
with the angled
connection to the
machine.
Attention !
Do not place the inlet hose downwards.
Angle the hose to the left or right depending
on the position of your water tap.
3. Set the hose correctly by loosening the ring
nut. After positioning the inlet hose, be sure to
tighten the ring nut again to prevent leaks.
4. Connect the hose to
a tap with a 3/4”
thread. Always use the
hose supplied with the
appliance.
45°
35°
Waterstop
The inlet hose is provided with a water stop
device, which protects against damage
caused by water leaks in the hose which could
develop due to natural ageing of the hose.
This fault is shown by
a red sector in the
window «A» Should
this occur, turn the
water tap off and refer
to your Service
Centre to replace the
hose.
The inlet hose must not be lengthened. If it is
too short and you do not wish to move the tap,
you will have to purchase a new, longer hose
specially designed for this type of use.
Water drainage
The end of the drain hose can be positioned in
three ways:
Hooked over the
edge of a sink using
the plastic hose
guide supplied with
the machine. In this
case, make sure the
end cannot come
unhooked when the
machine is emptying. This could be done by
tying it to the tap with a piece of string or
attaching it to the wall.
A
132970521.qxd 01/04/2008 11.55 Pagina 25