Filter
Top Products
Cancelling the Delay Start after having started the
programme:
1. Set the washing machine to PAUSE by pressing
button .
2. Press button repeatedly until the display shows 0'.
3. Press button again to start the programme.
• The door will be locked throughout the delay time.
If you need to open the door, you must first set the
washing machine to PAUSE by pressing button
and wait a few minutes before opening the door.
After you have closed the door, press the same
button again.
The Delay Start cannot be selected with
the draining programme.
It is possible to change some options before the
programme carries them out.
Before you make any change, you must pause the
washing machine by pressing button 4.
Changing a running programme is possible only by
resetting it. Turn the programme selector dial to
and then to the new programme position. Start the
new programme by pressing button 4 again.
The washing water in the tub will be not emptied out.
Press the button to interrupt a programme which is
running.
Press the button again to restart the programme.
Turn the selector dial to to cancel a programme
which is running, and wait few minutes to open the
door (it is possible only if in the tub there is not
water).
The machine stops automatically.
The blinking zero appears on the display.
If a programme or an option that ends with water left
in the tub has been selected, the door is locked to
indicate that the water must be emptied out before
opening the door.
Follow the below instructions to empty out the water:
1. Turn the programme selector dial to .
2. Select the draining or spinning programme.
4
6
4
Important!
4
Important!
Altering an option or a running programme
Interrupting a programme
4
Cancelling a programme
At the end of the programme
O
O
O
3. Reduce the spin speed if needed, by pressing the
relevant button.
4. Press button .
At the end of the programme, the door is released,
after few minutes, and can be opened. Turn the
programme selector dial to to switch the machine
off.
Remove the laundry from the drum and carefully
check that the drum is empty. If you do not intend to
carry out another wash, close the water tap. Leave
the door open to prevent the formation of mildew and
unpleasant smells.
1. Once the programme has finished after a few
minutes the energy saving system will be enabled.
The brightness of the display and the indicator pilot
lights are off.
2. If the appliance is switch on but in PAUSE, only the
4
Stand-By:
O
brightness of the display is off.
By pressing any button the appliance will come out of
the energy saving status.
12