Filter
Top Products
16
Malfunction
Possible Cause / Solution
The machine stops when the proce-
dure has not been finished
Power failure or water cut.
The water inside the inner barrel has been drained
but there is still a small amount of water in the
drainage pump and pipe. The drainage pump
continuously work and takes in the air, then there
wil be noise which is normal situation.
The machine stops for some time
during the wash procedure.
The washing machine adds water automatically.
There is too much foam in the tube, the foam is
being drained.
Foam spills from the detergent
drawer
Check if the amount of detergent is excessive,
if it is the specialized detergent for the drum
washing machine.
Reduce the amount of detergent used next time.
Dip one scoop of the softener mixed with 1/2 liter
of water to the detergent box II.
If the washing machine cannot work normally, a alarm code will appear on the display. Please carry
out the following checks.
Display
Reason
Solutions
Open the water tap, to check if the inlet hose is squashed
or kinked, check if the filter in the inlet valve is blocked or
not; check if the water pressure is too low.
Check if the drain pump is blocked (see page 11).
Check if the voltage is too high if it is this case, a constant
voltage device is needed.
Inlet water
overtime
Overtime of
the drainage
The door has
not been closed
Voltage is
too high
Check if the door of the washing machine is closed check
if the clothes are trapped by the door seal.
˙
Try to use again or contact your local service center if the
problem persists.
Others
Alarm codes
The drainage pump is noisy during
operation after the water has been
drained.