Zanussi ZWF 1621S Washer User Manual


 
7
• set the washing machine to PAUSE by pressing the
Start/Pause button;
• press the Delay Start button once, the light relevant to
the selected delay goes off .
• press the Start/Pause button again to start the
programme.
Important!
The selected delay can be changed only after
selecting the washing programme again.
The door will be locked throughout the delay time.
If you need to open the door, you must first set the
washing machine to PAUSE by pressing the
Start/Pause button and then wait about 2 minutes.
After you have closed the door, press the
Start/Pause button again.
The delay start can not be selected with Spin and
Drain programmes.
7 Programme progress display
When you choose the delayed start, the light relevant to
the selected delay lights up.
After the machine has started, the remaining time is
shown by the corresponding indicator light.
During the programme, only the “Washing” light stays
on. When the programme has finished, the “End” pilot
light comes on.
The “End” light flashes in the event of operating
problems:
4 flashes: door open
2 flashes: problem with water draining
1 flash: problem with water supply
For more information see paragraph “Something not
working”?
8 Spin speed selector dial
This dial allows you to reduce the final and the
intermediate spin speeds or to select the NO SPIN or
RINSE HOLD (anti-crease) option.
The speeds on the dial refer to cotton programmes.
Position 1400 (or 1500 or 1600 depending on the
model) corresponds to:
900 r.p.m. for Synthetics, Wool and Handwash, or
700 r.p.m. for Delicates and Miniprogram.
Position 500 (or 700) corresponds to:
450 r.p.m. for Delicates and Miniprogram, or
500 r.p.m. for Synthetics, Wool and Handwash.
NO SPIN: by selecting this option all the spinning
phases are suppressed. To be used for extremely
delicate items.
The machine will add 3 rinses on cotton
programmes and 1 rinse on synthetic programmes.
RINSE HOLD (anti-crease): by selecting this
option the water of the last rinse is not emptied out
to prevent the fabrics from creasing. When the
programme has finished the phase light “End” is on,
the Start/Pause light is off and the door is blocked to
indicate that the water must be emptied out.
To do this:
turn the programme selector dial to “O
select the Drain or Spin programme.
Using the spin speed selector dial you can choose the
desired spin. If the dial remains on position RINSE
HOLD or NO SPIN the machine will perform the
spin speed at 400 rpm.
depress Start/Pause button.
9 Programme selector dial
The selector dial is divided into following sections:
Cotton and linen
Synthetic
Delicates and Handwash
Wool
Miniprogram
Special programmes:
(Rinses), (Drain) and
(Spin)
132984670.qxd 13/12/2005 10.22 Pagina 7