Filter
Top Products
19
10. Select the Start/Pause
To start the selected programme, press the
Start/Pause button; the corresponding green
pilot light stops flashing.
The «Lock» light
illuminates to indicate
that the appliance starts
operating and the door
is locked.
The “Lock” light indicates if the door can be
opened:
● light on: the door cannot be opened.
The appliance is running.
● light off: the door can be opened.
The washing programme is finished.
To interrupt a programme which is running,
depress the Start/Pause button: the
corresponding green pilot light starts to flash.
To restart the programme from the point at
which it was interrupted, press the Start/Pause
button again.
If you have chosen a delayed start, the
machine will begin the countdown.
IMPORTANT!
If an incorrect option is selected, the red pilot
light of the Start/ Pause button flashes for 3
times and the message Err is displayed for
about 2 seconds.
11. Select the Delay Start
90
Delay Start
Start/Pause
Lock
Before you start the programme, if you wish to
delay the start, press repeatedly the «Delay
Start» buttons and , to select the
desired delay.
The selected delay time value (up to 20 hours)
will appear on the display for about 3 seconds,
then the duration of the programme will appear
again.
You must select this option after you have set
the programme and before you press the
Start/Pause button.
The wash programme can be delayed from 30
mins - 60 mins - 90 mins, 2 hours and then by
1 hour up to a maximum of 20 hours by means
of this button.
Selecting the delayed start:
● Select the programme and the required
options.
● Select the delay start.
● Depress “Start/Pause” button: the machine
starts its hourly countdown.
The programme will start after the selected
delay has expired.
Cancelling the delayed start:
You can cancel the delay time at any moment,
before you press the Start/Pause button.
If you have already pressed the Start/Pause
button, and you wish to cancel the delay time,
proceed as follows:
• set the washing machine to PAUSE by
pressing the Start/Pause button;
• press the Delay Start buttons once until the
symbol 0’ is displayed.
• press the Start/Pause button again to start
the programme.
Operating sequence
Smart 132973880.qxd 23/06/2008 12.22 Pagina 19