Zanussi ZWF 1437 W Washer User Manual


 
9
9 “Start/Pause” button
This button has two functions:
Start: after you have selected the desired programme
and options, press this button to start the washing
machine. The light above the button will stop flashing
and remain lit.
If you have selected a delay time by means of the
Delay” button, the countdown will begin and will be
shown on the display.
Pause: when you press this button again, the
programme in progress is interrupted. The light above
the button will start flashing. To restart the
programme, press the button again.
When you PAUSE the cycle, and it becomes possible
to open the door, provided
• the washing machine is not in the heating phase;
• the level of the water is not high;
• the drum is not turning.
Important!
You must set the washing machine to Pause before you
make any change in the programme in progress.
10 “Skip/Reset” button
This button performs two functions:
- Clears the memory
- Selects special programmes
At the end of every programme the Reset button must
be pressed once or repeatedly to clear the programme
memory. This will be confirmed by three dashes,
flashing in the display.
If the previous programme is not cleared, the display
will show a “
0” flashing and an audible signal will
sound, when you switch the machine on.
Selecting a special programme:
A wash programme must be selected in the normal way.
(“Start/Pause” button not pressed)
Start/
Pause
The “Skip” button is then used to cancel or advance the
programme to the required phase.
The “Skip” button can only operate during the selection
of the programmes or when the programme is in pause.
A normal wash cycle consists of the following phases,
Wash - Rinses - Spin and is confirmed by the
illumination of the corresponding LED,s.
To select rinses & spin, press the “Skip” button once,
the wash LED goes out.
To select spin only, press the “Skip” button twice.
The wash & rinses LED,s go out.
Wash
Rinses
Spin
Drain
Prewash
Wash
Rinses
Spin
Drain
Prewash
Wash
Rinses
Spin
Drain
Prewash