Filter
Top Products
7
To complete the cycle, press “Skip Reset” button once,
all the leds are off, then choose one of the following
options:
• Drain only: press FABRIC button in order to select
the desired programme and press the “Skip Reset”
button until the only led “Drain” illuminates.
Depress “Start/Pause” button
• Drain and Spin: press FABRIC button in order to
select the previously selected programme (the type of
fabric just washed) and press the “Skip Reset” button
until the only led “Spin” illuminates.
You can change the spin speed by means of “Spin”
button if needed, then depress “Start/Pause” button.
6 “Option” button
Press this button to select the following options:
● Prewash: select this option if you wish your laundry
to be prewashed at 30° C before the main wash (not
available for Wool programme).
The prewash ends with a short spin at 650 rpm in
programmes for cotton and synthetic fabrics, whereas
in the programme for delicate fabrics the water is only
drained.
● 40° AA: this option can be selected for cottons and
synthetics lightly or normally soiled with a
temperature of 40°C or higher.
The washing temperature will be reduced and the
washing time will be prolonged in order to achieve an
AA class in energy efficiency and washing
performance.
● Half Load: select this option to reduce water
consumption on the rinse cycle when washing a smaller
load of cottons or linens (maximum load size = 3 kg).
The machine perform 2 rinses instead of 3.
The Prewash, the 40° AA and the Half Load options
cannot be selected together by means of the same
button.
Prewash
Half
Load
40° AA
7 “Start/Pause” button
This button has two functions:
• Start: after you have selected the desired programme
and options, press this button to start the washing
machine. The light above the button will stop flashing
and remain lit.
• Pause: when you press this button again, the
programme in progress is interrupted. The light above
the button will start flashing. To restart the
programme, press the button again.
When you PAUSE the cycle, and it becomes possible
to open the door, provided
• the washing machine is not in the heating phase;
• the level of the water is not high;
• the drum is not turning.
Important!
You must set the washing machine to Pause before you
make any change in the programme in progress.
8 “Skip/Reset” button
This button performs two functions:
- Clears the memory
- Selects special programmes
At the end of every programme the Reset button must
be pressed once or repeatedly to clear the programme
memory (all the LED,s must be off); otherwise, the next
time you switch the washing machine on, the audible
warning signals relevant to the end of the previous cycle
will be given.
Selecting a special programme:
A wash programme must be selected in the normal way.
(“Start/Pause” button not pressed)
Start/
Pause