Filter
Top Products
2222
Unpacking
The transport safeguard must be removed before
putting the appliance into operation.
Important !
You are advised to keep all the packaging for re-use in
case the machine is to be transported again.
●
After removing all the packaging, with assistance
carefully lay machine on it’s back to remove the
polystyrene base from the bottom.
●
Remove the power supply cable and the draining hose
from the hose holders on the rear of the appliance
●
With a suitable spanner unscrew and remove the
central rear bolt A. Slide out the relevant plastic
spacer.
●
Unscrew and remove the two large rear bolts B and
the six smaller bolts C.
●
Remove the bracket D and tighten up the six smaller
bolts C.
●
Open the porthole and remove the polystyrene block
fitted with the adhesive tape on the door seal.
C
C
HEC0014
HEC0011S
D
C
C
B
HEC0003S
B
HEC0002S
A
HEC0001
HEC0008
●
Fill the smaller upper hole and the two large ones with
the corresponding plastic plug caps supplied in the
bag containing the instruction booklet.
Important!
All the different plug caps are supplied with the
appliance in the plastic bag containing the instruction
booklet.
●
Connect the water inlet hose as described under the
paragraph “Water inlet”.
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is not
impeded by carpets, rugs etc. Check that the machine does
not touch the wall or other kitchen units.
Never place cardboard, wood or similar materials under the
machine to compensate for any unevenness in the floor.
Your new washing machine has been designed to be
permanently plumbed in to your home’s water supply
and drainage system. However, if this is not possible, it
may be connected to a suitable existing tap with the
drain hose discharging into a sink.
The appliance has an inlet hose, with female 3/4” BSP
thread connector. If this connection is not compatible
with the plumbing of the existing installation, a variety
of connectors are available from good hardware stores
and plumbers merchants to suit most domestic
plumbing. Any alteration to your existing plumbing
must be carried out by a competent person, or qualified
plumber.
Installation on a Suspended Floor
Suspended wooden floors are particularly susceptible to
vibration. To help prevent vibration we recommend you
place a waterproof wood panel, at least 15 mm thick
under the appliance, secured to at least 2 floor beams
with screws. If possible install the appliance in one of
the corners of the room, where the floor is more stable.
HEC0005
HEC0010
Ofrecido por www.electromanuales.com