Filter
Top Products
23
Installation instruction
Unpacking
All transit bolts and packing must be removed
before using the appliance.
You are advised to keep all transit devices so
that they can be refitted if the machine ever
has to be transported again.
1. After removing all the packaging, carefully
lay machine on it’s back to remove the
polystyrene base from the bottom.
2. Remove the power supply cable and the
hoses from the hose holders on the rear of
the appliance.
3. Unscrew the three bolts with a suitable
spanner.
4. Slide out the relevant plastic spacers.
5. Open the porthole and remove the
polystyrene block fitted on the door seal.
6. Fill the smaller upper hole and the two large
ones with the corresponding plastic plug
caps supplied in the bag containing the
instruction booklet.
Positioning
Install the machine on a flat hard floor. Make
sure that air circulation around the machine is
not impeded by carpets, rugs etc. Check that
the machine does not touch the wall or other
kitchen units. Level the washing machine by
raising or lowering the feet. The feet may be
tight to adjust as they incorporate a self locking
nut, but the machine MUST be level and
stable.If necessary, check the setting with a
spirit level.
Any necessary adjustment can be made with a
spanner.
Accurate levelling prevents vibration, noise and
displacement of the machine during operation.
Never place cardboard, wood or similar
materials under the machine to compensate for
any unevenness in the floor.
132960380.qxd 22/09/2008 9.09 Pagina 23