Filter
Top Products
SHOWER
WASHING
MACHINE
DISHWASHER
BATH
SINK
TOILET
BIDET
RAINWATER
‘RUN-OFF’
SURFACE WATER
DRAINS & SEWERS
UNTREATED
DISCHARGE
RIVER RIVER
TREATED DISCHARGE
FOUL DRAIN
FOUL SEWERS
SEWAGE TREATMENT
WORKS
Electrical connection
Any electrical work required to install this appliance
should be carried out by a qualified electrician or com-
petent person.
Warning! THIS APPLIANCE MUST BE EARTHED.
The manufacturer declines any liability should this
safety measure not be observed.
Before switching on, make sure the electricity supply
voltage is the same as that indicated on the appliance’s
rating plate.
Warning! Information on the electrical connection
is given on the rating plate on the inner edge of the
appliance door.
The appliance is supplied with a 13 amp plug fitted.
In the event of having to change the fuse in the plug sup-
plied, a 13 amp ASTA approved (BS1363/A) fuse must be
used.
Should the plug need to be replaced for any reason, pro-
ceed as described below.
The wires in the mains lead are coloured in accordance
with the following code:
1
2
3
4
1 Green & Yellow
2 Brown
3 Cord clamp
4 Blue
The wire coloured green and yellow must be connected
to the terminal marked with the letter «E» or by the earth
symbol
or coloured green and yellow.
The wire coloured blue must be connected to the terminal
«N» or coloured black.
The wire coloured brown must be connected to the ter-
minal marked «L» or coloured red.
Upon completion there must be no cut, or stray strands
of wire present and the cord clamp must be secure over
the outer sheath.
Warning! A cut off plug inserted into a 13 amp
socket is a serious safety (shock) hazard.
Ensure that the cut off plug is disposed of safely. Should
the appliance power supply cable need to be replaced,
this must be carried out by our Service Force Centre. The
appliance should not be connected to the electrical supply
by means of an extension cable.
Note!
When the appliance is installed the power supply cable
must be accessible.
Permanent connection
In the case of permanent connection it is necessary that
you install a double pole switch between the appliance
and the electricity supply (mains), with a minimum gap
of 3 mm between the switch contacts and of a type suitable
for the required load in compliance with the current elec-
trical regulations.
The switch must not break the yellow and green earth
cable at any point.
Environment concerns
The symbol on the product or on its packaging
indicates that this product may not be treated as
household waste. Instead it should be taken to the
appropriate collection point for the recycling of electrical
and electronic equipment. By ensuring this product is
disposed of correctly, you will help prevent potential
negative consequences for the environment and human
health, which could otherwise be caused by inappropriate
waste handling of this product. For more detailed
information about recycling of this product, please
21