Filter
Top Products
1 Detergent dispenser drawer
2 Programme selector dial
The selector dial is divided into the following sections:
• Cottons (blue colour),
• Synthetics (green colour)
• Delicates (gray colour)
• Wool (Handwash) (gray colour)
• Rinses, Drain, Spin and Mini 30° (green colour)
• “O” Off = Reset/Switching the machine off
The selector dial can be turned either clockwise or
anticlockwise.
E- position corresponds to the ENERGY SAVING
programme for cotton and synthetics and position “O”
Off to Reset programme/Switching off of the machine.
corresponds to a cold wash
At the end of the programme the selector dial must be
always turned to position “O” Off , to switch the
machine off .
Attention!
If you turn the programme selector dial to another
programme when the machine is working, the warning
«Err» message appears for 3 seconds on the display
while the buzzer sounds 3 times .
95°
60°
40°
30°
60°
30°
Cottons
30°
Rinses
Wool
40°
Delicates
40°
Spin
Drain
Off
40°
30°
Synthetics
Mini
30°
6
The Control Panel
12345678910
95°
60°
40°
30°
60°
30°
Cottons
30°
Rinses
Wool
40°
Delicates
40°
Spin
Drain
Off
40°
30°
Synthetics
1100
900
700
500
Spin
Start/
Pause
Delay
Time
Washing
Door
End cycle
Time
ZWF 1111 W
Night
Cycle
Option
Load
Prewash
Quick
Extra rinse
1/2
Mini
30°
3 “Spin” button
Press this button repeatedly to change the spin speed, if
you want your laundry to be spun at a speed different
from the one proposed by the washing machine or to
choose the “Rinse Hold” option. The relevant light
will light up.
Maximum speeds for the different models are:
• for cottons: 1100 rpm for ZWF 1111 W and 1300
rpm for ZWF 1311 W
• for synthetics fabrics and Wool: 900 rpm;for
• for delicate fabrics and Mini 30°: 700 rpm.
“Rinse Hold” position: when you choose this option,
the machine will not drain the water of the last rinse, so
as not to crease the laundry.
At the end of the cycle, the light of the “Start/Pause”
button goes out, the “End cycle” light illuminates and
the “Door” light stays on (the door is locked) to
indicate that the water must be drained. A flashing zero
appears on the display.
To complete the cycle, there are 2 possibilities for
emptying out water:
• Select programme “Drain”: the water is emptied out
without spinning.
IMPORTANT!
By pressing the Half Load and Start Pause buttons
simultaneously for about 3 seconds, the acoustic
signal is deactivated at the end of the cycle, when
selecting the programmes and in case of an incorrect
option selection .
By pressing these 2 buttons again the acoustic signal
is reactivated.