Zanussi ZWF 1223 Washer User Manual


 
Open the pump door.
Put a container below the recess of the drain pump to
collect the water that flows out.
Press the two levers and pull forward the drainage duct
to let the water flow out.
When the container is full of water, put the drainage
duct back again and empty the container. Do steps 3
and 4 again and again until no more water flows out
from the drain pump.
1
2
Pull back the drainage duct.
Unscrew the filter and remove it.
Remove fluff and objects from the pump.
Make sure that the impeller of the pump can turn. If this
does not occur, contact the service centre.
2
1
Clean the filter under the water tap and put it back in the
pump into the special guides.
Make sure that you tighten correctly the filter to prevent
leakages.
Close the pump door.
15