Filter
Top Products
16
Altering an option or a running programme
It is possible to change any option before the
programme carries it out. Before you make any
change, you must pause the washing machine
by pressing the Start/Pause button.
Changing a running programme is possible
only by resetting it. Turn the programme
selector dial to Off and then to the new
programme position. The washing water in the
tub will not empty out. Start the new
programme by depressing the Start/Pause
button again.
Interrupting a programme
Depress the Start/Pause button to interrupt a
programme which is running, the
corresponding light starts to flash. Depress the
button again to restart the programme.
Cancelling a programme
Turn the selector dial to Off to cancel a
programme which is running. Now you can
select a new programme.
Opening the door after the programme has
started
First set the machine to pause by pressing the
Start/Pause button.
The «Door» light flashes and after 2 minutes
goes off, the door can be opened.
If the «Door» light does not flash, this means
that the machine is already heating, that the
water level is above the bottom edge of the
door or that the drum is turning.
In this case the door can not be opened.
If you cannot open the door but you need to
open it you have to switch the machine off by
turning the selector dial to «Off».
After about 2 minutes the door can be opened
(pay attention to the water level and
temperature!).
At the end of the programme
The machine stops automatically. The
Start/Pause and «wash» lights go off and the
«end» phase light illuminates. The door can be
opened (the Door light is off).
If the «Rinse Hold» or «Night Cycle» option
has been selected, the «end» and «door»
lights illuminate but the door remains locked to
indicate that the water must be emptied out
before opening the door.
To empty out the water please read the steps
on the Rinse Hold option paragraph.
Turn the programme selector dial to «Off» to
switch the machine off. Remove the laundry
from the drum and carefully check that the
drum is empty.
If you do not intend to carry out another wash,
close the water tap. Leave the door open to
prevent the formation of mildew and
unpleasant smells.
Smart 132973860amended.qxd 20/09/2007 10.38 Pagina 16