Filter
Top Products
15
Select the required programme by turning
the programme selector dial ( )
Turn the programme selector dial to the
required programme. The green light of button
starts to flash.The selector dial can be
turned either clockwise or anticlockwise.
Position «Off» to Reset programme/Switching
OFF of the machine.
At the end of the programme the selector
dial must be turned to position «Off», to
switch the machine off.
IMPORTANT!
If you turn the programme selector dial to
another programme when the machine is
working, the red light of button will flash 3
times to indicate a wrong selection. The
machine will not perform the new selected
programme.
Select the spin speed, the Night Cycle or
Rinse Hold option by pressing button
When selecting a programme, the light
corresponding to the maximum speed allowed
for that programme will illuminate (refer to the
section «Programme table» for the maximum
allowed by each cycle spin speed).
Select the desired option by pressing the
buttons and
Depending on the programme, different
functions can be combined. These must be
selected after choosing the desired programme
and before pressing the button . The
relevant light will light up.
In any case, if an option is chosen that is not
allowed with the selected programme, the red
light of the button starts flashing.
Start the programme by pressing button
The corresponding green pilot light stops
flashing. The appliance starts operating and
the door is locked.
5
5
5
43
2
5
5
1
Press the same button to interrupt a
programme which is running, the
corresponding green pilot light starts to flash.
To restart the programme from the point at
which it was interrupted, press the button
again.
If you have chosen a delayed start, the
machine will begin the countdown.
Select the Delay Start by pressing the
button
If you wish to delay the start, press this button
repeatedly to select the desired delay. The
relevant light illuminates.
You must select this option after you have set
the programme and before you press the
button .
You can cancel the delay time at any time,
before you start the programme.
If you have already pressed the button ,
and you wish to cancel the delay time, proceed
as follows:
• set the washing machine to PAUSE by
pressing the button ;
• press the button once, the light relevant
to the selected delay goes off.
• press the button again to start the
programme.
IMPORTANT!
• The selected delay can be changed only after
selecting the washing programme again.
• The door will be locked throughout the delay
time. If you need to open the door, you must
first set the washing machine to PAUSE by
pressing the button and then wait a few
minutes until the door lock is released.
After you have closed the door, press the
button again.
The Delay Start can not be selected with
«Drain» programme.
5
5
5
7
5
5
5
7
5
132963780.qxd 14/05/2008 9.43 Pagina 15