Filter
Top Products
4
Your New Washer-Dryer
●
Automatic cooling of the wash water to 60°C
before draining, with the 95°C programme. This
reduces thermal shock to fabrics, helping to prevent
creasing.
●
The special wool programme with its new delicate
wash system treats your woollens with extreme
care.
●
The drying programmes will enable you to have
dry and soft laundry in a short time.
Ecological hints
To save water and energy and help protect the
environment, we recommend that you follow these
hints:
●
The machine works more economically if it is fully
loaded (for both washing and drying cycles).
●
Adjust the quantity of detergent according to the
hardness of your water supply, the amount of
laundry and the degree of soiling.
●
A programme without prewash is sufficient for
normally soiled laundry.
●
With adequate pre-treatment, stains and limited
soiling can be removed; the laundry can then be
washed at a lower temperature.
●
Select a “quick” programme for lightly soiled
laundry.
●
The machine will consume less energy if the laundry
is adequately spun before being dried.
In the interest of the environment
●
Materials marked with the symbol are
recyclable.
●
Check with your local Council or Environmental
Health Office to see if there are facilities in your area
for re-cycling this appliance.
●
When the appliance is to be scrapped, cut off the
power supply cable and make the door lock device
unusable to prevent young children from being
trapped inside.
●
Help to keep your country tidy - use authorised
disposal sites for your old appliance.
How do we help to protect the environment? We
use recycled paper!
Your new washer-dryer, fitted with the Zanussi “JET SYSTEM”, meets all modern requirements for effective
treatment of laundry with low water, energy and detergent consumption.
Even small loads are washed “economically” because the amount of water used is regulated automatically according
to the load and type of fabric.
Important
Your machine is fitted with a balance control device, which ensures the machine is stable during the spin.
If the wash load appears not to have been spun sufficiently at the end of the wash cycle, because it is not
evenly distributed in the drum, the balance control device may have operated. It will therefore be necessary
to redistribute the wash load manually and select a spin programme. For more detailed information see the
section headed "Something Not Working".
124973311 ZJD1285.qxd 9/22/00 12:11 PM Pagina 4 (Nero quadricromia/Process Black pellicola)