Filter
Top Products
6 DELAY START button
This button allows you to delay the starting of the
programme by 12 hours max.
This option must be selected after having selected
the programme and before pressing START/PAUSE
to start the programme.
Every time the button is pressed, the time is
increased by 30 minutes, until the display shows a
delay of “2 hours”. After this, the delay is displayed
hour by hour.
The minutes or hours of delay that have been
selected are displayed for 2 seconds, then the display
shows the duration of the previously selected
programme.
The countdown begins after you have pressed the
START/PAUSE button.
To cancel the delay time press the START/PAUSE
button and after press the DELAY START button
until the display indicates 0’. Then press the
START/PAUSE button again.
When the delay is cancelled, the display shows 0’ and
after the duration of the programme.
During the delayed start, it is not possible to change
the programme or the delay time that have been
selected. To do this, you must first switch off the
machine by setting the programme selector dial to
“RESET/OFF”. Select the new programme, the
options and the delayed start, then press the
START/PAUSE button.
During the delayed start, to cancel or change
functions that have been selected, simply set the
appliance to PAUSE. Once you perform the desired
operation, press once again the START/PAUSE
button.
If you wish to add more laundry while the machine is
performing the countdown, simply open the door.
When you close the door, press the START/PAUSE
button again to cause the countdown to be resumed.
7 DISPLAY
The display shows the following information:
• duration of selected programme
• delayed start
• end of programme
• incorrect option selection
• alarm code
• Duration of selected programme
After you have selected the programme, its
duration (in hours and minutes) appears on the
display. It is calculated automatically on the basis
of the maximum load accepted for each type of
fabric and of the required degree of drying.
When the programme starts, the remaining time is
displayed every 5 minutes.
• Delayed start
If you have selected a delay time by means of the
relevant button, the display shows it for 2 seconds;
then it shows the duration of the previously
selected programme.
The countdown is displayed every 30 minutes until it
displays “90 minutes” and then hour by hour.
• End of programme
A flashing zero indicates the end of the
programme and it is displayed after the “anti-
creasing” phase.
0
3
1.20
6
125983910.qxp 2006-05-08 15:00 Page 6