Zanussi WJS 1265 W Washer/Dryer User Manual


 
8
Selected drying time in minutes or hours and
minutes.
After the programme has started the time remaining is
updated every minute.
The washing machine has stopped with water in
the tub, at the end of a programme with the RINSE
HOLD option: this is indicated by a static zero.
The washing machine has completed the
programme: this is indicated by a blinking zero. At
the same time, the door locked light goes out. The
zero will reappear when you switch the washing
machine on, unless the previous programme has been
erased by means of the SKIP RESET button.
Important!
The first time you use the washing machine, when
you switch it on, it may display a blinking zero and give
an audible warning signal. This is due to the fact that the
washing machine has performed a washing cycle during
the manufacturer’s inspection tests, and this cycle has
not been erased after its completion.
Delay start, a time value indicated in hours and
selected by means of the relevant button.
0
1.25
The delay time is displayed for 3 seconds, then the
duration of the selected programme reappears.
After you have pressed the START/PAUSE button, the
countdown begins, and the delay time value decreases
by one unit every hour.
You can delay the start of the selected programme by
up to 24 hours in one hour intervals.
An incorrect option selection has been made: this is
indicated by the message Err when a function
incompatible with the current programme is selected.
The incorrect selection is also indicated by an audible
warning signal.
An alarm code indicates a fault in the machine
operation (see the relevant chapter on page 23-24).
10 START/PAUSE button
This button has three functions:
Start: after you have selected the desired programme
and options, press this button to start the machine. The
light above the button will stop flashing and remain lit.
If you have selected a delay time by means of button
12, the countdown will begin and will be shown on
the display.
Pause: when you press this button again, the
programme in progress is interrupted. The light above
the button will start flashing. To restart the
programme, press the button again.
E20
132999022 WJS1265-1465-1665W.qxd 9/13/01 11:15 AM Pagina 8 (Nero/Process Black pellicola)