Filter
Top Products
ENGLISH
77
a) Door
The dimensions of the door should be:
- width 595-598 mm
- thickness 16-22 mm
The height (C-Fig. C) depends on the height of
the adjacent furniture's base.
b) Hinges
To mount the hinges it is necessary to drill two
holes (dia. 35 mm, depth 14 mm) on the inner
side of the door. The distance between the holes
must be 416 mm.
The distance (B) from upper edge of the door to
the centre of the hole depends on the adjacent
furniture's dimensions.
The required dimensions are given in the picture
C.
The hinges will be fixed to the door by means of
screws for wood (2-Fig. B).
c) Mounting the door
Fix the hinges to the machine by means of the
M5x8 screws (3-Fig. B). The hinges can be
adjusted to compensate for possible uneven
thickness of the door.
To align the door perfectly it is necessary to
loosen the screw (3-Fig. B), adjust the door and
tighten the screw again.
d) Counter-magnet (6)
The appliance is pre-arranged for a magnetic
closure of the door. To enable a correct operation
of this device, it is necessary to screw the
counter-magnet (6) (steel disk + rubber ring) into
the inner side of the door.
Its position must correspond to the magnet (4) on
the appliance (see picture D).
If the door has to be opened from left to right,
invert the position of the plates (7), the magnet
(4) and the rubber cap (5) (Fig. B and E). Mount
the countermagnet (6) and the hinges (1) as
previously described.
Ø 35 mm - Depth 14 mm
16-22
B
C
22+1,5
595-598
416
P0026
C
P0984
6
4
D
4
6
5
1
2
3
7
E
P0983
132999660 WIJ1075.qxd 16/05/01 14.25 Pagina 77 (Nero/Process Black pellicola)