Filter
Top Products
21
Unpacking
Before installing the machine the packing and
transit bolts must be removed. The transit
packaging is red for ease of identification.
Please retain the packing and transit bolts for
re-use in case the machine is to be transported
again.
Unpack the appliance. Tilt the appliance
backwards. Remove the polystyrene base, by
turning the appliance one quarter turn.
Remove the base (fig. 1).
Open the lid and remove the polystyrene block
and wedges securing the drum.
Close the lid (fig. 2).
Using a spanner, remove the two transit bolts
(A) (fig. 3).
The holes which are now visible must be filled
with the plugs (B) provided (fig. 4).
Retain the polystyrene block and transit bolts
for future use (fig. 5).
To enable the appliance to be pushed further
into the recess, the plastic crossbar holding the
hoses at the back of the appliance can be cut
off (fig. 6).
Positioning
The installation surface must be clean dry and
level
Do not install on deep pile carpet.
Do not install the appliance in locations where
the temperature may fall below freezing
Please ensure that when the appliance is
installed it is easily accessible for the
engineer in the event of a breakdown
Fig. 1
Fig. 2
Fig 4
Fig 6
B
A
Fig 3
Fig 5