Filter
Top Products
6
When the washing cycle begins, the
«washing» light is on.
3.7. Action during a program
3.7.1. Adding of laundry
Press the Start/Pause pushbutton : the corresponding
light flashes as long as the program is paused. The
opening of the lid is possible only 2 minutes after the
washing machine stops. Press the same pushbutton
again to resume the program.
For reasons of safety, you cannot open the cover if the
temperature of the washing water is too high.
3.7.2. Modifying the current program
Before modifying the current program, you must put the
washing machine to pause by pressing on the «Start/
Pause» pushbutton. If it is impossible to make the
modification, the corresponding light flashes for few
seconds. If you decide to change the program in any
case, you will need to cancel the current program (see
below).
3.7.3. Cancelling the program
If you want to cancel a program, turn the program
selector knob to the «off» position of the program
selector.
You can then select a new program after cancelling the
previous one.
3.8. End of program
The washing machine stops automatically. The «cycle
end» light goes on. The opening of the lid is only
possible 2 minutes after the washing machine stops.
If you choose the rinse hold pushbutton, the rinse hold
light illuminates to inform you that water has to be
drained before you can open the cover. To terminate
the cycle, you can then spin the washing by choosing
the spinning program or drain it by choosing the drain
program.
Turn the program selector knob to the «Off» position.
Take out the washing.
Pull out the power supply plug and close the water sup-
ply tap.
Note: we recommend that you should leave the cover
and the drum open after use to air the washing drum.