Filter
Top Products
6
123456 11
7
9
8
10
GH J K
EXTRA
DRY
BABY
DRY
STORE
DRY
SLIGHTLY
DAMP
L
DRY
FRESH
6
XTRACAPACITY
WRING
DRY
SLIGHTLY
DAMP
STORE
DRY
READY
TO WEAR
EXTRA
DRY
IRON
DRY
SYNTHETICS
START
BUZZER
OFF
ON-OFF
ELECTRONIC SENSOR
AUTOREVERSE
T
D
E 4
2
3
4
W
IMPORTANT: PLEASE READ THE INSTRUCTION BOOK BEFORE USING THIS APPLIANCE
LOW
TEMP.
SELECTOR
ABCDE F
TIMED
PROGRAMME
COTTON
The Control Panel
1 Programme Chart
This will help you to select the correct programme
for drying.
2 Mains-On Light
It comes on when the appliance is switched on (ON-
OFF button pressed down) and goes out when this
button is released.
3 ON-OFF Button
This button is used to switch the dryer on. At the end
of the programme, release this button by pressing it
again to switch the dryer off.
4 Low Temperature Button
Pressing this button allows drying to be performed at
a lower temperature, for delicate items.
The corresponding pilot light comes on.
5 Buzzer OFF Button
Press this button when selecting the programme if
you wish to switch the buzzer off during the anti-
creasing phase.
The corresponding light illuminates.
6 Start Button
Press this button for about 2 seconds to start the dryer
after having selected the drying programme.
If the door is opened while the programme is
running, this button must be pressed again after
closing the door in order to re-start the
programme from the point at which it was
interrupted.
This button must also be pressed after a power cut.
In both cases light or (depending on the
phase in progress) flashes to remind you that the start
button needs to be pressed again.
7 “Drying” Light
This light indicates that the machine is performing
the drying phase.
8 “Cooling” Light
This light indicates that the appliance is in the
cooling phase. At the end of drying, there is a 10
minute cooling phase to cool the laundry.
If light or is flashing, this means that the
Start Button needs to be pressed again for the
programme to resume.
9 “End of Programme” Light
This light flashes at the end of the cooling phase and
during the anti-creasing phase.
10 “Anti-creasing” Light
This light flashes alternately with the light at the
end of the drying phase (after cooling) and during the
anti-creasing phase.
If only light flashes, this means that the anti-
creasing phase has finished.
11 Programme/Time Selector Dial
It allows you to select electronically controlled or
time controlled drying.
Turn the dial to the required programme or time.
125993380.qxd 12/10/02 11:33 AM Pagina 6 (Nero/Process Black pellicola)