Filter
Top Products
12
12. How to change a programme
during its cycle
Before you make any change, you must pause the
washing machine by pressing the START/PAUSE
button.
It is possible to change any phase before the programme
carries it out.
Changing the type of fabric or temperature is possible,
obviously, only during the washing phase. When you
make a change in these two parameters, the washing
machine will resume the cycle from the beginning.
If it is necessary to drain the water in order to change the
programme in progress, proceed as follows:
• PAUSE the machine by pressing the START/PAUSE
button;
• press the SKIP/RESET button repeatedly, until only
the DRAIN light remains lit;
• press the START/PAUSE button again.
When the water has been drained, the display shows a
blinking zero. You may now select a new programme
and press the START/PAUSE button to start it.
13. How to cancel a programme
during its cycle
To cancel a programme that is being carried out, first
pause the washing machine by pressing the
START/PAUSE button, then press the SKIP/RESET
button repeatedly, until the display shows three blinking
dashes.
14. How to open the door during
the cycle of a programme
You can open the door, after having set the washing
machine to PAUSE, provided the following conditions
exist:
• the washing machine is not in the heating phase
beyond 40°C;
• the level of the water is not high;
• the drum is not turning.
If these requirements are met, when you pause the
washing machine, the DOOR LOCKED light goes out
and the door can be opened.
Should it not be possible to open the door, and should it
be absolutely necessary to do so, switch the machine off
by pressing the ON/OFF button.
After approximately 2 minutes, you can open the door.
Pay attention to the level and temperature of the
water in the washing machine!
When you close the door and press the ON/OFF button
again, the washing machine will resume the programme
from the point where it had been interrupted.
15. End of programme
At the end of the programme, the washing machine
stops automatically, gives an audible signal, and displays
a blinking zero.
If you had selected the RINSE HOLD option, the
START/PAUSE button light flashes to indicate that the
water must be drained. The display shows a steadily lit
zero.
When the programme has been completed, a blinking
zero appears on the display and the audible signal is
given.
The DOOR LOCKED light goes out at once.
Press the SKIP/RESET button repeatedly to erase
the programme that has just been carried out. If you
omit to do this, the next time you switch the washing
machine on, the blinking zero will appear on the
display and you will hear the audible signal.
Note: when you switch the machine on, if you must
erase the previously performed programme, it is also
sufficient to press the FABRIC button and select a new
programme.
Press the ON/OFF button to switch the machine off. The
relevant light will go out.
Remove the laundry from the washing machine.
Check whether the drum is completely empty, by
rotating it with your hand. The purpose of this is to
prevent any items of laundry from remaining
accidentally in the drum, where they might get damaged
in a subsequent wash (e.g. by shrinking) or bleed colour
into another load of laundry.
We advise you to close the water supply tap and
disconnect the plug from the socket.
Leave the door ajar in order to air the washing machine.
124971146 IZ10...IZ16.qxd 8/27/01 8:55 PM Pagina 12 (Nero/Process Black pellicola)