Filter
Top Products
11
11. How to cancel a programme
during its cycle
To cancel a programme that is being carried out, first
pause the washing machine by pressing the
START/PAUSE button, then press the SKIP/RESET
button repeatedly, until the phase indicator lights go out.
12. How to open the door during
the cycle of a programme
You can open the door, after having set the washing
machine to PAUSE, provided the following conditions
exist:
• the washing machine is not in the heating phase
beyond 55°C;
• the level of the water is not high;
• the drum is not turning.
If these requirements are met, when you pause the
washing machine, the DOOR LOCKED light goes out
and the door can be opened.
Should it not be possible to open the door, and should it
be absolutely necessary to do so, switch the machine off
by pressing the ON/OFF button.
After approximately 3 minutes, you can open the door.
Pay attention to the level and temperature of the
water in the washing machine!
When you close the door and press the ON/OFF button
again, the washing machine will resume the programme
from the point where it had been interrupted.
13. End of programme
At the end of the programme, the washing machine
stops automatically and gives an audible signal.
If you had selected the RINSE HOLD option, the light
of the START/PAUSE button goes off, the phase
indicator lights and go on and the DOOR
LOCKED light remains lit to indicate that the water
must be drained.
To complete the cycle, first press SKIP/RESET button
and then choose one of the following options:
• Drain only :
- Press FABRICS button in order to select the desired
programme and press 3 times SKIP/RESET button
until the light illuminates. Then depress
START/PAUSE button.
• Drain and Spin :
- Choose the previously selected programme by means
of the FABRICS button, afterwards change the spin
speed if needed, by means of the SPIN SPEED button
and then press SKIP/RESET button twice until the
light goes on and then depress START/PAUSE
button.
When the programme has been completed the audible
signal is given.
The DOOR LOCKED light goes out at once.
Press the SKIP/RESET button repeatedly to erase
the programme that has just been carried out. If you
omit to do this, the next time you switch the washing
machine on, you will hear the audible signal.
Note: when you switch the machine on, if you must
erase the previously performed programme, it is also
sufficient to press the FABRICS button and select a new
programme.
Press the ON/OFF button to switch the machine off.
The relevant light will go out.
Remove the laundry from the washing machine.
Check whether the drum is completely empty, by
rotating it with your hand. The purpose of this is to
prevent any items of laundry from remaining
accidentally in the drum, where they might get damaged
in a subsequent wash (e.g. by shrinking) or bleed colour
into another load of laundry.
We advise you to close the water supply tap and
disconnect the plug from the socket.
Leave the door ajar in order to air the washing machine.