Filter
Top Products
7
• Drain and Spin :
- Choose the previously selected programme by means
of the FABRICS button, afterwards change the spin
speed if needed, by means of the SPIN SPEED button
and then press SKIP/RESET button twice until the
light goes on and then depress START/PAUSE
button.
6 OPTIONS button
Press this button to select the following options:
• PREWASH: select this option if you wish your
laundry to be prewashed before the main wash (not
available for wool).
The prewash ends with a short spin in programmes
for cotton and synthetic fabrics, whereas in the
programme for delicate fabrics the water is only
drained.
• 40 AA: this option can be selected for cottons and
synthetics lightly or normally soiled with a
temperature of 40°C or higher.
If you select 40°C together with option 40 AA, the
machine will prolong the time at 40°C in the washing
phase. On cotton programme this will allow an A class
in energy efficiency and washing performance to be
achieved.
If you select 95°C, 60°C or 50°C and press the 40 AA
button, the washing temperature will be reduced and
the washing time will be prolonged.
The PREWASH, the 40 AA and HALF LOAD options
cannot be selected together by means of the relevant
button.
• HALF LOAD: select this option to reduce water
consumption on the rinse cycle when washing a smaller
load of cottons o linens (maximum load size=2.5 kg).
The machine perform 2 rinses instead of 3.
7 START/PAUSE button
This button has two functions:
• Start: after you have selected the desired programme
and options, press this button to start the washing
machine. The light above the button will stop flashing
and remain lit.
• Pause: when you press this button again, the
programme in progress is interrupted. The light above
the button will start flashing. To restart the
programme, press the button again.
Important! You must set the washing machine to
PAUSE before you make any change in the programme
in progress.
8 SKIP/RESET button
At the end of a programme, you must press this button
once or repeatedly, in order to clear the contents of the
memory; otherwise, the next time you switch the
washing machine on, the audible warning signals
relevant to the end of the previous cycle will be given.
You can also press the SKIP/RESET button to exclude
one or several phases of the programme which is
running, as indicated below.
- set the washing machine to PAUSE by pressing the
START/PAUSE button (the relevant light will flash);
- press the SKIP/RESET button once or several times, until
the required phase(s) is(are) cancelled (the light next to
the symbol of the phase(s) will go out).
Example:
In this case, the spin (at
the speed provided for
the selected type of
fabric) will be
performed.
This button allows you also to select special
programmes, such as RINSES, SPIN and DRAIN.
• If the machine is already switched on because it has
just performed a washing programme, proceed as
follows:
- depress SKIP/RESET button once or repeatedly to
cancel the previously performed programme (all the
phase indicator lights must be off);
- select the type of fabric by means of the relevant
button;
- select the special programme:
• RINSES AND SPIN
Depress SKIP/RESET once, the pilot light
(WASH) goes out.
• SPIN
Depress SKIP/RESET twice, the pilot lights WASH
and RINSES go out.