Filter
Top Products
27
HOW TO USE THE CONTROLS DETERGENT AND ADDITIVES
1. LOADING THE WASHING MACHINE
Load the laundry loosely, alternating large items with small
ones.
Do not overload the washing machine, but always try to use
its utmost capacity in accordance with the type of fabric.
Reduce the quantity when washing very dirty or fluffy
laundry .
Once the machine is working and you wish to add any item
you must stop the program.
IMPORTANT REMARK: This appliance is provided with a
security device to avoid opening during the cycles. Open it
only when absolutely necessary and wait 2 to 3 minutes
after you have stopped the machine to give the safety
device time to unlock.
2. DOSE THE WASHING POWDER
Pull the handle to open the
dispenser. Enter the
advised quantity of washing
powder into
compartment
For prewash use
compartment
3. DOSE THE ADDITIVES
If you wish to use additives
enter the softener in the
compartmente with the
symbol and the
bleacher in the
compartment with the
symbol Never exceed
the MAX level.
4. SELECT THE TEMPERATURE
Turn the dial clockwise to the desired temperature .
5. SELECT THE PROGRAM
Turn the dial clockwise until the marker reaches the desired
program.
6. START
Before pressing the On/off Button check if:
The door is properly closed.
The appliance is plugged in.
The water supply tap is turned on.
The drain filter is tight.
The drain hose is adequately positioned.
Pull the program dial up to you till it klicks.
The pilot light comes on and the program will begin.
7. STOP
The washing machine stops automatically once the cycle is
finished, the pilot goes out. Open the door 2 to 3 minutes
after the end of the program to give the safety device
time to unlock.
Close the tap and unplug the appliance. Leave the door
ajar for a few minutes for the steam to get out.