Filter
Top Products
8
A normal wash cycle consists of the following phases,
Wash - Rinses - Spin and is confirmed by the
illumination of the corresponding LED,s.
To select rinse & spin, press the SKIP button once, the
wash LED goes out.
To select spin only, press the SKIP button twice.
The wash & rinse LED,s go out.
To select Drain, press the SKIP button three times, the
wash - rinse - spin LED,s go out.
If you wish to cancel or advance the running programme
to the required phase, PAUSE the cycle and then press
the SKIP button as previously described.
PREWASH
WASH
RINSES
RINSE HOLD
SPIN
DRAIN
CLOGGED FILTER
END
9 Programme phase indicator
lights
When you select a programme, the lights relevant to the
phases that form the programme light up.
After you have started the programme, only the light
relevant to the phase that is currently being carried out
will remain lit.
At the end of the cycle the light will illuminate.
If at the end of the programme the light comes on,
this means that the drain filter must be cleaned (see page
17).
The END light flashes if there are operating
problems. At the same time one of the following lights
comes on indicating the type of problem:
: problem with the water supply
: problem with water draining
: door open
See paragraph “Something Not Working”.
132996290_FLE1016W.qxd 8/25/01 2:53 AM Pagina 8 (Nero/Process Black pellicola)