Zanussi FJS 1425 W Washer User Manual


 
7
Draining and spin:
- Press the START/PAUSE button. The machine will
drain the water, then spin the laundry at the
maximum speed provided for the selected
programme.
- Select spin speed by means of button 5, and press
the START/PAUSE button.
Drain only
- Press the SKIP/RESET button once, so as to cause
the DRAIN light to light up, then press the
START/PAUSE button.
Important! If you accidentally press the SKIP/RESET
button more than once, the display will show three
blinking dashes. To cause the washing machine to
drain the water, select any washing programme by
means of the FABRIC button, then press
SKIP/RESET three times in order to select the
DRAIN position (only the DRAIN light will remain
lit).
6 OPTIONS button
Press this button to select the following options:
PREWASH: select this option if you wish your
laundry to be prewashed before the main wash (not
available for wool and hand-wash cycle).
The prewash ends with a short spin at 650 rpm in
programmes for cotton and synthetic fabrics, whereas
in the programme for delicate fabrics the water is only
drained.
SUPER RINSE: this option can be selected with all
programmes except the wool programme and hand
wash. The machine performs 4 rinses instead of 3.
This option is recommended for people who are
allergic to detergents, and in areas where the water is
very soft.
7 TIME SAVE button
This button allows you to select the QUICK WASH
function, for laundry that is only slightly soiled (not for
wool and HAND WASH programme).
The washing time will be reduced according to the type
of fabric and the selected temperature.
8 Display
The following pieces of information are shown on the
display:
Three blinking dashes, when a programme is
cancelled by means of the SKIP/RESET button.
The three blinking dashes will also appear when you
press the ON/OFF button to switch the machine on, if
the previously selected cycle has been erased.
Duration of washing programme in hours
and minutes, after you have selected a programme.
While the programme is running (after you have
pressed the START/PAUSE button), the displayed
time value decreases by one unit every minute.
The washing machine has stopped with water in the
tub, at the end of a programme with the RINSE
HOLD option: this is indicated by a static zero.
The washing machine has completed the
programme: this is indicated by a blinking zero. At
the same time, the door locked light goes out. The
zero will reappear when you switch the washing
machine on, unless the previous programme has been
erased by means of the SKIP RESET button.
0
2.05
---
124970982.qxd 9/4/01 2:49 AM Pagina 7 (Nero/Process Black pellicola)