Filter
Top Products
17
If you are unable to identify or solve the
problem, contact your local Service Centre.
Before telephoning, make a note of the
model, serial number and purchase date of
your machine: the Service Centre will
require this information.
1206
If you call out an engineer to a fault listed
below, or to repair a fault caused by
incorrect use or installation, a charge will be
made even if the appliance is under
guarantee.
Malfunction Possible cause Solution
When pressing a button,
the corresponding
button flashes several
times.
• Washing protection.
After the start of the pro-
gramme, the option can no
longer be set.
• Turn the programme knob to
OFF. Set the programme again
Drying cycle ends
shortly after programme
starts. END
light illuminated.
• Not enough washing
loaded
or washing loaded is too
dry for selected programme.
• Select time programme or
higher drying level (e.g.
EXTRA DRY instead of CUP-
BOARD).
Programme inactive,
Condenser
light illuminated.
• Water reservoir is full.
• Empty the water reservoir,
then start programme with
START/PAUSE button.
Drying cycle lasts an
unusually long time.
Note:
After around 5 hours
the drying cycle ends
automatically (see
„Drying cycle complete“)
• Lint filter clogged.
• Heat exchanger clogged
with lint.
• DELICATE button pressed
and load volume too big.
• Load volume too big.
• Laundry insufficiently
predrained.
• Clean lint filter
• Clean heat exchanger.
• DELICATE is only suitable for
use with loads of up to 3 kg!
• Reduce load volume.
• Laundry must be adequately
pre-drained.
Important: