Filter
Top Products
36
SPECIFICATIONS
Problem Possible Causes Solutions
Power is not turned on
Is the power cord plugged in properly?
y
Has a house fuse blown, a circuit breaker
y
tripped, or a power outage occurred?
Make sure that the plug is secured in a
y
grounded 3-prong, 120 V (60 Hz) outlet.
Reset the circuit breaker or replace the fuse.
y
Do not increase the fuse capacity. If the
problem is a circuit overload, have it corrected
by a qualified electrician.
The door does not open
when the cycle pauses or
finishes
Is the temperature in the tub too high?
y
Is the water level in washer high?
y
The washing machine has a safety lock built
y
into the door to prevent burning. Leave the
door closed and wait until the door lock icon
disappears from the display.
Allow the washer to complete the
y
programmed cycle, or run the DRAIN & SPIN
cycle to drain the water.
The wash cycle time is
longer than usual
Is the washing machine overloaded? Are other
y
options added to the wash cycle?
This is normal. The washing machine
y
automatically adjusts the cycle time for the
amount of laundry, water pressure, water
temperature, and other operating conditions.
It is musty or moldy in the
tub
Has the incorrect detergent been used?
y
Did you clean the tub periodically?
y
Use only HE (High-Efficiency) detergent
y
recommended for a front-loading washing
machine.
See page 29, clean the inside and outside of
y
the washing machine periodically.
Model WM2250C*
Description Front-Loading Washer
Electrical requirements 120 VAC @ 60 Hz.
Max. water pressure 14.5 - 116 PSI (100 - 800 kPa)
Dimensions 68.6 cm (W) X 75.6 cm (D) X 98.3 cm (H), 129.5 cm (D with door open)
27" (W) X 29
3
/
4
" (D) X 38
11
/
16
" (H), 51" (D with door open)
Net weight 180.8lb (82kg)
Max. spin speed 1200 RPM
SPECIFICATIONS