Operating Your Washer
In This Section
Paw
Paw
Before starting your washer T5 .............................
9electing a cycle and time
..............................
6
Starting or stopping your washer .................... .5
Using rinse and spin
........................................
6
6elacting a load size
..........................................
5
Using drain and spin
.......................................
6
6eleclfng wash+inse temperaturw ................ .6
mat happens in each cyck .......................... .9
Operating your washer properly assures maximum washing efficiency. This section gives you
important information to help you to select a cycle, time, and temperature for your wash load.
Before starting your washer
Add measured detergent. Then place a
sorted load in the washer before starting.
See page 11 for additional “Before you wash”
information.
NOTE: If your washer has a Consumer Buy
Guide, remove it and place it with your Use
and Care Guide.
Starting or stopping your washer
Starting your washer:
1. Push in the Cycle Control Knob and turn it
clockwise. Stop when the indicator on the
knob’s outer ring points to the number in
the wash cycle you want. The numbers are
minutes of wash time. Make other selec-
tions, if necessary.
2. Pull out the Cycle Control Knob.
Refer to pages 6-9 for additional information to
help you make selections.
Stopplng and restarting your washer:
l To stop the washer at any time, push in the
Cycle Control Knob.
l To restart the washer, close the lid (if
necessary) and pull out the Cycle Control
Knob.
Selecting a load size
Position the Load Size Selector at the setting
that corresponds to the size load you want to
wash.
Select a load size based upon the size of
the load and the fabric you are washing. See
page 11 for additional loading information.
To change the load size setting after the
washer has started to fill, move the Selector to
the desired new setting.
5
