Filter
Top Products
Operating Your Washer
In This Section
Page
Page
Before
starting your washer
..............................
5
Selecting a cycle
and time
.............................. 6
Starting
or stopping your washer
....................
.5
Using rinse and spin
.......................................
9
Selecting a load size
..........................................
5
Using drain and spin
.......................................
9
Selecting
wash-rinse temperatures
.................
.6
What happens
in each cycle
......................... 10
Operating your washer properly assures maximum washing efficiency. This section gives you
important information to help you to select a cycle, time, and temperature for your wash load.
Before starting your washer
Add measured detergent. Then place a sorted
NOTE:
If your washer has a Consumer Buy
load in the washer before starting. See page 14
Guide, remove it and place it in your Use and
for additional “Before you wash” information.
Care Guide.
Starting or stopping your washer
Starting your washer:
1. Push in the Cycle Control Knob and turn it
clockwise. Stop when the indicator on the
knob’s outer ring points to the number in the
wash cycle you want. The numbers are
minutes of wash time.
2. Select a load size and water temperature.
3. Pull out the Cycle Control Knob.
Refer to pages 6-l 0 for additional information
to help you make selections.
Stopping and restarting your washer:
l
To stop the washer at any time, push in the
Cycle Control Knob.
l
To restart the washer, close the lid (if neces-
sary) and pull out the Cycle Control Knob.
Selecting a load size
Your washer has a knob or slide Load Size
Selector. Position the Load Size Selector at the
setting that corresponds to the size load you
want to wash.
Select a load size based upon the size of the
load and the fabric you are washing. See
page 14 for additional loading information.
l
If your washer has a knob Load Size Selec-
tor, turn selector to the desired load size.