Filter
Top Products
Solving laundering problems
Most laundering problems are easily solved if you understand the cause. Check the following
list for problems you may have and possible causes. If you need additional help, check the
“Assistance or Service” section of this book.
PROBLEM
Brown, yellow
stains
Dye transfer
CAUSE
l Chlorine staining
l Iron in water heater or pipes
l Iron and manganese in water
l Improper sorting
l Load not immediately removed from washer after end of cycle
Gray whites,
dingy colors
Greasy looking
spots
l Improper sorting
l Water temperature too low
l Not enough detergent
l Using soap in very hard water (use detergent if you have hard water)
l Undiluted fabric softener or fabric softener poured directly on load
l Fabric softener in wash water
l Not enough detergent
Lint
l Improper sorting
l Paper or tissue in pockets
l Pilling being mistaken for lint
l Overloading
l Not enough detergent
l Cloaaed lint filter (models with a manual clean lint filter)
Load too wet
l Cold rinses
l Lid is opened before spinning is completed
l Fabric type (some knits stretch during manufacturing-laundering returns
fabric to original size)
l Care label directions not followed
Snags, rips, holes
Stiff, rough fabrics
(usually cottons)
l Items damaged before washing
l Misuse of chlorine bleach
l Sharp articles not removed from pockets
l Overloading
l Fasteners not fastened
l Using soap in very hard water (use detergent if you have hard water)
l Not enough detergent
l Line drvina
Twisting, tangling
l Overloading
l Improper loading (do not wrap large items around agitator)
Wrinkling
l Overloading
l Load not immediately removed from washer after end of cycle
l Improper rinse temperature
l Cycle selection is incorrect (based on fabric type)
Yellow areas
(from body oils)
l Water temperature too low
l Not enough detergent
20