Filter
Top Products
8
Wash Temp
Hot
Some cold water is added to save
energy. This will be cooler than
your hot water heater setting.
Warm
Some cold water will be added, so
this will be cooler than what your
previous washer provided.
Cool
Warm water may be added to
assist in soil removal and to help
dissolve detergents.
Cold
This is the temperature from your
faucet. If your tap cold water is
very cold, warm water may be
added to assist in soil removal and
help dissolve detergent.
Suggested Fabrics
8. Select WASH TEMP
Once you select a cycle, select the desired wash temperature
by turning the Wash Temp knob to the appropriate setting
based on your load. All rinses are tap cold.
NOTE: Always read and follow fabric care label instructions
to avoid damage to your garments.
10. Press START/Pause
to begin wash cycle
Press the START/Pause button to start the wash cycle. When
the cycle has nished, the DONE indicator will light. Promptly
remove garments after cycle has completed to avoid odor,
reduce wrinkling, and rusting of metal hooks, zippers, and
snaps.
Unlocking the lid to add garments
If you need to open the lid to add 1 or 2 missed garments:
Press START/Pause; the lid will unlock once the
washer movement has stopped. This may take several
minutes if the load was spinning at high speed. Then close
lid and press START/Pause again to restart the cycle.
If lid is left open for more than 10 minutes, the water will pump
out automatically.
Select the desired cycle options. If you are using fabric
softener, be sure to select one of the Fabric Softener options.
Whites and pastels
Durable garments
Heavy soils
Bright colors
Moderate to light soils
Colors that bleed
or fade
Light soils
Dark colors that
bleed or fade
Light soils
9. Select options, if desired
Select the load size setting most suitable for your load. Small
will add a low amount of water for smaller loads and Ex Large
will add the most amount of water for large or bulky loads.
Items need to move freely.
7. Select LOAD SIZE
Replace inlet hoses after 5 years of use to reduce the risk of
hose failure. Periodically inspect and replace inlet hoses if
bulges, kinks, cuts, wear, or leaks are found.
When replacing your inlet hoses, mark the date of replacement
on the label with a permanent marker.
NOTE: This washer does not include inlet hoses. See the
“Installation Instructions” for more information.
WATER INLET HOSES
WASHER MAINTENANCE
Wash Temp
Tap Cold
This is the temperature from
your faucet.
Suggested Fabrics
Dark colors that
bleed or fade
Light soils