Whirlpool W10254491A Washer User Manual


 
13
CLEANING THE PRECISION DISPENSE
ULTRA CARTRIDGE
It is recommended that you rinse out the Precision
Dispense Ultra cartridge when changing detergent types or
concentrations, or when the washer will not be used for
an extended period.
1. Pull dispenser out until it stops.
2. Lift out the Precision Dispense Ultra cartridge.
3. Lift cover on cartridge and ush interior thoroughly with
warm water.
4. Allow to air dry or wipe with a clean, soft towel.
IMPORTANT: Cartridge is not dishwasher safe.
WASHER MAINTENANCE
CLEANING YOUR WASHER
Keep your washer as clean and fresh as your clothes.
To keep washer interior odor-free, follow this recommended
cleaning procedure at least once a month:
1. Make sure laundry drum is empty.
2. Using recommended AFFRESH
®
washer cleaner, add
one tablet to washer basket
OR
If using liquid chlorine bleach, add 1 cup (250 mL) to
liquid chlorine bleach dispenser.
IMPORTANT: Do not add detergent to CLEAN WASHER
cycle. Do not use more than recommended amount of
bleach to avoid damaging product over time.
3. Close washer door.
4. Press POWER.
5. Select CLEAN WASHER with Affresh
cycle.
6. Press and hold START/PAUSE.
NOTE: The basket will rotate, then the door will unlock,
lock again, and then the cycle will continue. The washer
will add some water, and the basket will rotate while
the washer runs a short sensing cycle. This will take
approximately 3 minutes.
7. The cycle will determine whether clothing or other items
are in the washer. If no items are detected in the washer,
it will proceed to Step 8.
If any items are detected in the washer, a reminder will
be displayed on the screen and the door will unlock.
Open and remove any garments in the wash drum.
Press POWER to cancel the error message. Then repeat
steps 3–6 to start the cycle again.
8. Once the cycle has started, allow it to nish. If you must
cancel the cycle before it has nished, press POWER. A
conrmation message will appear in the display. It may
take up to 10 minutes for the door to unlock.
9. After the cycle has ended, leave the door open slightly,
to allow for better ventilation and drying of washer
interior.
To clean exterior:
1. Use a soft, damp cloth or sponge to wipe up any spills.
2. Use mild soap and water if needed.
IMPORTANT: To avoid damaging washer nish, do not use
abrasive products.