Filter
Top Products
5
Firmly grasp power cord (A) and
pull to completely free power
cord, cord restraint (B), and pin (C)
from rear panel. Pull cord restraint strap (D) out of plug.
NOTE: Remove cotter pin if it did not come free with strap.
Remove straight power cord
and cord restraint
3.
To remove restraint from power cord: push power cord in,
press tab, and then pull power cord out.
4. Remove restraint from power cord
Firmly grasp yellow shipping
strap (A) and pull until both ends
are completely removed from
washer. Pull cord restraint strap (B)
out of plug.
NOTE: Check that two (2) cotter pins (C) came off with strap.
5. Remove looped power cord
tab
restraint
power cord
CONNECT DRAIN HOSE
Gently pull hose out of back of washer cabinet from top until
end emerges.
IMPORTANT: Do not force excess drain hose back into rear
of washer.
For a laundry tub or standpipe drain, follow steps 8 and 9.
For a oor drain, do not install drain hose form. You may need
alternate parts with separate directions. See “Tools and Parts”
to determine what you may need.
Feed hose into one end of form. Bend hose and feed through
other side, anchoring form on smooth sections of hose.
8. Connect drain hose form
Remove drain hose from washer
cabinet
6. Place power cord over console
Gently place power cord over console to allow free access to
back of washer.
7.
B
C
A
D
C
A
B