Filter
Top Products
16
A. External ground conductor screw
B. Neutral ground wire
C. Center silver-colored terminal
block screw
D. Neutral wire (white or center wire)
E.
3
⁄4" (1.9 cm) UL listed strain relief
A. 3-wire receptacle (NEMA type 10-30R)
B. 3-wire plug
C. Neutral prong
D. Spade terminals with upturned ends
E.
3
⁄4" (1.9 cm) UL listed strain relief
F. Ring terminals
G. Neutral (white or center wire)
Power supply cord,
3
-wire connection:
Use where local codes permit connecting
cabinet-ground conductor to neutral wire.
1. Loosen or remove center silver-colored
terminal block screw.
2. Connect neutral wire (white or center
w
ire) of power supply cord to the center,
silver-colored terminal screw of the
terminal block. Tighten screw.
3. Connect the other wires to outer terminal
block screws. Tighten screws.
4. Tighten strain relief screws.
5. Insert tab of terminal block cover into
slot of dryer rear panel. Secure cover
with holddown screw.
6. You have completed your electrical
connection. Now go to “Venting
Requirements.”
C
B
A
D
E
F
G
C
B
A
D
E