Filter
Top Products
15
Assured Water Temp
Assured Water Temp electronically senses and maintains a
uniform water temperature. It regulates incoming hot and cold
water. It is automatically turned On when a cycle is selected. See
“Preset Cycle Settings” in “Cycles.”
Assured Water Temp is available with WARM/WARM, WARM/
COLD and COLD/ COLD settings. HOT/COLD (top) and COLD/
COLD (bottom) are for tap water that is not temperature
controlled.
■ Assured Water Temp ensures consistent cleaning.
■ When you are using Assured Water Temp on COLD/COLD,
warm water is added to the washer to maintain a temperature
of approximately 75°F (24°C). Detergents dissolve at
temperatures of 60°F (15.5°C) and above.
■ Warm washes are regulated at approximately 100°F (38°C).
■ Warm rinses are regulated at approximately 75°F (24°C). This
is a cooler warm rinse than you are used to, but it saves
energy, reduces wrinkling, and gives proper rinsing. The load
is a comfortable temperature to remove from the washer.
Soil Level
Soil Level is preset for each wash cycle. See “Preset Cycle
Settings” in “Cycles.” As you press Soil Level pad, the cycle time
(minutes) will increase or decrease in the ESTIMATED TIME
REMAINING display and a different Soil Level light will glow. To
get the minimum wash time, press the pad until the indicator light
next to REFRESH illuminates. This is the shortest wash time
available for that cycle.
When a wash cycle is started, the estimated time remaining for
the cycle, including fills and drains, will be displayed. The time
will count down to the end of the cycle.
Adjustable Cycle Signal
A tone will sound at the end of the cycle. The sound level of this
tone can be adjusted by pressing CYCLE SIGNAL. The volume of
tone you will hear at the end of the cycle will sound as the pads
are pressed.
Indicator Lights
Cycle
Located next to each pad, these lights show the cycle you have
selected.
Options
These lights show the Options you have selected.
Status
These lights show what portion of the cycle the washer is
operating. Soak and Extra Rinse status lights will glow if the
option was selected.
Operating Controls
Start
Press START to start your washer after a cycle has been
selected. Be sure all desired Options have been selected. The lid
must be closed for the washer to start.
Stop/Cancel
Press STOP/CANCEL once to pause or stop the washer at any
time. Press START to complete the cycle from where it was
stopped. Press STOP/CANCEL twice to turn off the washer.