Filter
Top Products
Selecting a cycle
Use pages 7 to 0 to find information about
drying cycles that may be on your model.
To Sebot I cycle:
1. Turn the Cycle Control Knob either way to
a desired time or setting.
2. Stop when the indicator points to the cycle
you want.
3. Push the Start Button.
ChWghgaOOfOCth:
1. TumtheCydeControfKnobtopointtoa
new setting.
2. Push the Start Button, if necessary.
NOTES:
l Use the Energy Preferred Automatic
Setting (e) to dry most loads. See page 8.
l The last few minutes of all cycles are
without heat to make the load easier to
handle.
l To help reduce wrinkling, remove the load
from the dryer as soon as tumbling stops.
This is important for permanent press,
knits, and synthetic fabrics.
l Do not overdry. Overdrying can osuse
shrinkage, static ding, and damage some
fabrics.
Flro Hazard
Do not dry heat-sensitive fabrics, plastic,
rubber, or some stuffed items with heat.
Use the Air cycle or line dry.
Failure to do so could result in fire or
damaged Items.
Using the Air cycle (no heat)
The dryer does not heat when the Cycle
Control Knob is set in the Air cycle. This
cyde can be used to fluff or air dry bedding,
plastic tablecloths, foam pillows, sneakers,
etc.
1. Turn the Cycle Control Knob to the number
of minutes you want in the Air cyde. (Cycle
is unheated.) Refer to the chart on page 0
for suggested times.
2. Push the Start Button.
NOTE: Repeat steps above if more time is
needed to dry items.