Filter
Top Products
Caring for your washer
To keep your washer looking like new:
l Wipe up detergent, bleach or other spills with
a soft, damp cloth as they occur.
l Sharp or heavy objects should not be put on
or in the washer. Check pockets for bolts,
nuts, etc.
l If the washer interior needs cleaning, put 1
cup (250 mL) of chlorine bleach and 2 cups
(500 mL) of detergent in the washer. Run
through a complete cycle using hot water.
l When removing hard water deposits, use
only cleaners labeled as being washer safe.
l After tinting or dyeing, put chlorine bleach
and detergent in the washer. Run through a
complete cycle using hot water to remove
excess dye or tint. If staining occurs on
following loads, repeat the process.
Saving energy
l Use hot water only when washing heavy,
greasy soils or whites.
. Use cold rinses.
l Wash full loads.
l Use lower water levels when washing small
loads.
l Avoid rewashing. Use enough detergent;
pretreat stains or heavy soils; do not over-
load; use the cycles and wash times recom-
mended for the fabric and soil; sort properly.
l Use your washer during off-peak hours-
usually early morning and late evening. (Ask
your power company.)
Winterizing your washer
Install and store your washer where it will not
freeze. Because some water stays in the
washer, freezing can damage it. If your washer
is stored or moved during freezing weather,
winterize it.
1. Shut off both water faucets. Disconnect the
drain water inlet hoses.
2. Put 1 quart (1 L) of R.V.-type antifreeze in
the basket.
3. Push in and turn the Cycle Control Knob
clockwise to just beyond any dot on the dial
(see “Using rinse and spin” on page 8).
4. Pull out the Cycle Control Knob and allow
the washer to run about 30 seconds to mix
the antifreeze and water.
To use the washer agaln . . .
1. Flush water pipes and hoses.
2. Reconnect water inlet hoses.
3. Turn on both water faucets.
4. Run the washer through a complete cycle
with 1 cup (250 mL) of detergent to clean
out antifreeze.
19