Whirlpool 8LSC6244BG0 Washer/Dryer User Manual


 
7
2. (OPTIONAL STEP) Pour measured liquid chlorine bleach into
the liquid chlorine bleach dispenser (on some models).
Bleach will be dispensed automatically during the wash part
of the cycle.
Never use more than 1 cup (250 mL) for a full load. Use
less with a smaller load size.
Follow the manufacturer’s directions for safe use.
To avoid spilling, use a cup with a pouring spout. Do not
let bleach splash, drip, or run down into the washer
basket.
Use only liquid chlorine bleach in this dispenser.
NOTE: On models without a bleach dispenser, see "Adding
Liquid Chlorine Bleach."
3. (OPTIONAL STEP) Pour measured liquid fabric softener into
the liquid fabric softener dispenser (on some models).
Softener is added automatically during the rinse portion of
the cycle.
Dilute liquid fabric softener by filling the dispenser with warm
water until liquid reaches the crossbar in the opening.
Do not spill or drip any fabric softener on the clothes.
Use only liquid fabric softener in this dispenser.
NOTE: On models without a fabric softener dispenser, see
"Adding Liquid Fabric Softener."
4. Close the washer lid.
5. Turn the WATER LEVEL selector (on some models) to the
correct setting for your wash load and the type of fabric being
washed.
Choose a load size that allows the load to move freely for
best fabric care. See "Loading".
You may change the load size selection after the washer
has started filling by turning the selector to a different
setting.
6. Set the TEMPERATURE selector (on some models) to the
correct setting for the type of fabric and soils being washed.
Use the warmest water safe for fabric. Follow garment label
instructions
NOTE: On models with temperature selections in the Cycle
Control knob, see "Cycle Time and Temperature Options" in
the "Selecting a Cycle and Time" section.
NOTE: In wash water temperatures colder than 70ºF
(21ºC), detergents do not dissolve well. Soils can be difficult
to remove. Some fabrics can retain wear wrinkles and have
increased pilling (the formation of small lint-like balls on the
surface of garments).
7. Push in the Cycle Control knob and turn it clockwise to the
wash cycle you want. Reduce the wash time when using a
small load size setting. See “Selecting a Cycle and Time.”
Pull out the Cycle Control knob to start the washer.
To stop or restart your washer
To stop the washer at any time, push in the Cycle Control
knob.
To restart the washer, close the lid (if open) and pull out
the Cycle Control knob.
Water Temp Use For
Hot
111°F (44°C)
or above
Whites and pastels
Heavy and greasy soils
Warm
90°-110°F
(32°-43°C)
Bright colors
Moderate to light soils
Cold
70°-90°F
(21°-32°C)
Colors that bleed or fade
Light soils