Filter
Top Products
If you need service or assistance,
we suggest you follow these five steps:
1.
Before calling for
assistance...
Performance problems often result
from little things you can find and fix
yourself without tools of any kind.
If your washer does not till:
l Is the power supply cord plugged
into a live circuit with the proper
voltage?
l Are both water faucets open?
l Have you checked your home’s
main fuses or circuit breaker box?
l Are the water supply hoses kinked?
l Is the Cycle Control Knob set and
pulled out?
If your washer does not spin:
l Is the lid closed?
l Is the power supply cord plugged
into
a live circuit with the Drover
l Have you checked your home’s
main fuses or circuit breaker box?
If your washer dmlns af the wrong
flme:
l The drain hose should be at least 28
Inches above the floor and secured.
20
l The drain hose should not fit tightly in
the drain pipe.
l Make sure that the Cycle Control
Knob is pointing to a number in the
cycle.
Make sure the dmln hose Is hlgher
than the wafer level in the washer. If
if Isnt..
l The washer may seem to be drain-
ing during wash and rinse cycles.
l Water can siphon out. (See “lnstalla-
tion Instructions:‘)
If your washer stops durlng a cycle:
l Remember, the washer pauses
briefly at different times in each cy-
cle. These pauses are normal.
If your dryer does not run or heat:
l Is the power supply cord plugged
into a live circuit with the proper
voltage?
l Is the door closed tightly?
l Did you push START?
l Have you checked your home’s
main fuses or circuit breaker box?
l The FLUFF AIR setting is without heat.
l The last minutes of heat settings are
without heat. See page 14.
l Is the gas turned on? If not, turn the
Control Knob to OFF. Turn on gas.
Wait 5 minutes. Reset controls and
start.
If drying ffmes seem too long:
l Is the lint screen clean? See page 17
of this book for cleaning instructions.
l See page 16 of this book and your
“Laundry Guide:’