Filter
Top Products
Other operating instructions
For a rinse and spin For a drain and spin
You may need an extra rinse and Your washer can be set to drain
spin for heavily soiled loads which
and spin out water.
need more detergent. (Extra de-
* Push Control Knob in.
tergent can require an extra rinse.)
l
Turn clockwise to the bar just before
l
Push Control Knob in.
OFF. See above drawing.
l
Turn clockwise to any.on the dial.
l
Pull Control Knob out.
See above drawing.
l
The washer will drain and spin.
l
Pull Control Knob out.
l
The washer will fill to selected
level; agitate 2 minutes; drain
and spin.
For agitation and spin speeds in each cycle.see pages 8 and 9.
For a soak or pre-wash
For best results, use warm water
for soaking or pre-washing stained
laundry. Hot water can set stains.
l
Use recommended amount of
detergent or pre-soak product.
l
Push Control Knob in.
l
Turn clockwise to point at a number
in the SCAK Cycle?
l
Pull Control Knob out to start washer.
l
When the cycle is over, add de-
tergent for the next selected wash
SOAK Cycle should
followed by a Wash
Important: See additional care
information on page 7 of your
“Laundry Guide!’
‘To start soak with agitation, the Cycle Control Knob
must point to a number in the SOAK Cycle.
Cleaning the lint filter
Water runs through the lint filter
whenever the washer agitates.
Check it often to make sure it’s clean
and is filtering at its best.
To remove it for cleaning, press the
release and pull straight out. Instruc-
tions for cleaning are printed on the
bottom of the filter.