Filter
Top Products
Mixed loads
When drying a load with different
kinds and weights of fabrics, use the
cycle suggested for the lightest fab-
rics. When the dryer stops, remove
dry Items and reset the control.
To help reduce wrinkling,take
the load from the dryer as soon
as tumbling stops. Th’is is very
important for permanent press,
knits and other synthetic fabrics.
Lint screen
Clean the lint screen before each load. A screen blocked by lint can
increase drying time and may be a FIRE HAZARD.
The lint screen is
inside the dryer p
drum, on the
stra
back wall.
0
1. Use the finger
holes to pull
the lint screen
straight out.
DO NOT run the dryer with
the lint screen loose, dam-
aged
or missing. Doing so
can cause overh8attng,
can damage fabrics and dryer
partsand can be a FIRE HAZARD.
1
2. Lightly
squeeze the
body, as
shown, while
pulling the
cover off
3. Roll lint off the
screen with
your fingers.
Squeeze body;
DO NOT rinse
pull cover off.
or wash the
screen. Wet lint is hard to remove.
4. Replace the cover on the body of
the lint screen.
5. Push the lint screen straight back
in until it clicks into place.
Lint removal
Lint can gather inside the dryer and create a fire hazard.
This lint should be removed every 2 to 3 years, or more otten,
depending on dryer usage.
Cleaning should be done only by a qualified service person.
1. Remove back panel from dryer
2. Avoid touching thermostats,
wires, terminals and heater box.
3. Remove lint from shaded area
-
see art - with a soft brush or
vacuum cleaner.
4. Replace back panel. Recon-
nect, exhaust duct, etc.
Level the washer/dryer,
l
Avoid electrical shock
hazard- unphrg power
supply cord or turn off
8l8clricat power.
. Avoid injury or damage-da not
put hands
k#ild8 Cabinet.
l
Metal edg8s
may be sharp.
l
Make sure dryer is cool.
Heat
Element Terminals
13