Filter
Top Products
Installation Instructions
0
Tilt washer forward,
raising back legs 1” off of
floor to adjust rear
self-leveling legs. Gently
lower washer to floor.
Check levelness of the
washer by placing a
carpenter’s level on the
top of the washer, first
side to side; then front to back.
If washer is not level,
screw the front legs up
or down to adjust and
repeat step 4.
Once the washer is level,
use wrench to turn nuts
on front legs up tightly
against washer base. If
nuts are not tight against
washer base, the washer
may vibrate.