Filter
Top Products
Operating Instructions
Continued
Using DAMP DRY
Use this setting to dry damp items that
do not require an entire drying cycle, or
to dry items to damp level. (Two exam-
ples are heavy cottons, such as jeans,
which you do not want to become stiff,
or cotton clothes which are easier to
press when damp.)
1. Set the Cycle Control Knob on
DAMP DRY in the TIMED DRYING
cycle.
2. Push the Start Button.
The dryer tumbles the load with heat
for 25 minutes, then without heat for
5 minutes.
End-of-cycle signal
The dryer sounds a signal to let you
know when the cycle is finished. The
signal can be turned on or off.
The signal is helpful when you are
drying permanent press, synthetics and
other items that should be taken out as
soon as the dryer stops. To use the
Cycle Signal:
l
Press the Cycle Signal ON pad before
a cycle starts. The ON indicator will
show. The signal will sound when the
cycle is finished.
l
If no signal is desired, press the Cycle
Signal OFF pad. Make sure the OFF
indicator is showing.
Lint signal
Clean the lint screen before each
load. If you neglect to clean your lint
screen, a signal will sound. The (whistle
tone) signal lets you know the air flow is
being restricted. Restricted air flow
reduces drying efficiency.
Turn off the dryer and clean the lint
screen as shown on page 11.