Filter
Top Products
Caring For Your Dryer
Continued
Ekccbk dryw with back
panel ren~ovad
Gss dryer
with lower frond
12
access panel rsmovd
Lint removal
tint can gather inside the dryer and be
a fuel for fire. It is recommended the
lint be removed every 2 to 3 years, or
more often, depending on dryer
usage. Cleaning.should tie done by a
qualified person. tf you have any
questions, please call our Consumer
Assistance Center at
l-800-253-1301.
I
Electrical Shock and
Personal Injury Hazard
l Unplug the power supply cord
or turn off the electrical power
before removing dryer panels.
1 l Make sure the dryer is cool.
l Dryer parts can have sharp
edges. Use care when han-
dling.
l When replacing front panel
after lint removal. the wire clips
holding the door switch wirea
must be anchored to top of
front and side panels. Wires
MUST NOT touch rotatlng
drum. (See page 13, step 7.)
Failure to do so could result in
electrical shock or personal
Injury.
If your dryer is electric, or is gas
and has a lower front access panel:
1. Unplug the power supply cord or
turn off the electrical power.
2. Remove back panel (electric) or
lower front access panel (gas). See
Installation Instructions.
3. Remove lint from shaded area in
illustration with
a
soft brush or
vacuum cleaner. Avoid damaging
wires, thermostats (electric), funnel
(gas) or igniter (gm).
4. Replace panel: reconnect and
level dryer again, if necessary.
NOTE: See page
13 if your dryer is
gas and has a full front panel.