Filter
Top Products
Lint removal
Heat etemont
temtlndr
Eketttcdryuwtthbeckpmelremovad
I
Lint can gather inside the dryer and be
a fuel for fire. It is recommended the lint be
removed every 2 to 3 years, or more often,
depending on dryer usage. Cleaning should
be done by a qualified person. If you have al
questions, please call our Consumer Assis-
tance Center at 1-800-253-l 301.
‘Y
Electrical Shock and
Personal injury Hazard
*Unplug the power supply cord or turn
off the electrical power before removing
dryer panels.
@Make sure the dryer is cool.
@Dryer parts can have sharp edges. Use
care when handling.
*When replacing front panel after lint
removal, the wire clips holding the door
switch wires must be anchored to top of
front and side panels. Wires MUST NOT
touch rotating drum. (See page 12,
step 7.)
Failure to do so could result in electrical
shock or personal injury.
if your dryer is electric, or is gas and has a
lower front access panel:
1. Unplug the power supply cord or turn off the
electrical power.
2. Remove back panel (electric) or lower front
access panel (gas). See Installation
Instructions.
3. Remove lint from shaded area in illustration
with a soft brush or vacuum cleaner. Avoid
damaging wires, thermostats (electric),
funnel (gas) or igniter (gas).
4. Replace panel; reconnect and relevel dryer,
if necessary.
NOTE: See page 12 if your dryer is gas and
has a full front panel.
Gas dryer with lower front
eccesfi panel removed
11