Filter
Top Products
Using Your Dryer
1.
Put the sorted load In the dryer
and close the door tightly.
2. Turn the Cycle Control Knob to
the cycle you want.
l
Use the Automatrc Cycles for most
loads. Start wrth the pornter at the
mrddle of an Automatrc Cycle. See
page 6 for more informatron.
NOTE:
In the Automatic Cycles, the
Cycle Control Knob does not keep
moving. It starts and stops, depend-
ing on the heat and the dryness of
the load.
l
Use TIMED DRYING for drying a certain
number of minutes, or for damp drying.
fluffing, or tumbling items without air.
3. Set TEMPERATURE SELECTOR.
l
Turn the
TEMPERATURE SELECTOR to
the drying temperature needed for the
load. See page 5 for suggested
settings.
4. Push the Start Button.
l
Make sure the door is closed and the
Cycle Control is set. If the door IS
opened during the cycle, the dryer
will
stop.
To restart the dryer,
close the
door and push the Start Button.
5. To stop the dryer:
l
Open the door.
l
Or, turn the Cycle Control Knob to one
of the OFF positions.
l
To change the setting while the
dryer is running,
turn the Cycle Control
Knob, either way. so it points to the set-
ting you want.
IMPORTANT: To help reduce wrin-
kling, take the load from the dryer as
soon as tumbling stops. This is very
important for permanent press, knits
and other synthetic fabrrcs.
-1
2
Setting Drying
Times -
Modern dryers are designed
with drying temperatures needed to
safely handle modern fabrics.
Cool-
down times have been added to heat
settings. You might notice slightly
longer drying times.
The time it takes to dry a load
depends on:
0 The kind of fabric, its weight, and the
size of the
load.
A large load of jeans
will take a lot longer to dry than a
small load of light synthetics.
0 The amount of moisture in the load.
Towels hold a lot of moisture; synthetics
don’t. Synthetics dry faster.
l
Temperature of the rinse water
Cold
rinses help save on energy and wrin-
kles, but a cold load will take slightly
longer to dry than a warm one.
l Amount
of linf
on the screen.
A full
lint screen slows the air flow and can
make drying time longer.
l
Temperature around the dryer. The
dryer heats room air. If the room air
temperature is not above 45°F (7.2”(Z),
drying time will be longer and removal
of wrinkles may be poor.
0 Proper instollotion and exhaust sys-
tems.
For the fastest possible drying
time, installing and exhausting your
dryer properly is important. See instal-
lation instructions.
4